Power a sub wherever you go
This compact mono subwoofer amplifier will power the bass in your vehicle with up to 300 watts RMS. That’s enough to hear the bass clearly above the noise of the road, trail, or waterway as you travel along. This powerhouse will fit almost anywhere, including a storage compartment on a boat, motorcycle, or ATV, so you can put great bass anywhere.
High-level inputs ease installation
It will accept a signal from just about any source, whether you’re using RCA cables from an aftermarket receiver or speaker wires from a factory radio. When you use the speaker-level inputs, the amplifier will sense the signal and turn itself on, so you won’t need to run a remote turn-on lead to your car stereo.
Compact Amplifier
The Kenwood KAC-M3001 compact Class D mono block amplifier is designed to drive a subwoofer (or two). The amp features a conformal coating on the circuit board to protect it from moisture. This allows you to use the amp for motorcycles, marine applications, or on All-Terrain Vehicles (ATVs). The KAC-M3001 delivers 200 watts RMS x 1 channel at 4 ohms. It also gives you 300 watts RMS x 1 at 2 ohms.
Power/Power Control Connections: The power, ground, and power control connections are 0.35″ wide screw terminals. A Phillips-head or flat blade screw driver (not supplied) is required to tighten/loosen the terminals. Spade connectors or ring terminals are recommended. Min. 10-gauge wire required for power and ground.
Power Control: The Power Control wire should be connected to the head unit’s remote turn-on lead when an aftermarket unit is used. This wire does not need to be connected if you’re using speaker level inputs. The Signal-sensing Turn-on feature will turn on the amp when an input signal is detected.
Line-Level Inputs: The amp is equipped with a pair of RCA inputs for connecting a stereo RCA patch cable from the head unit to the amp.
Kenwood Marine Mono Amp 2ohm Stable – 300 Watts RMS
