Please pay close attention to the vehicle fitment information in the “This will fit:” section below. We have also included the VIN of the donor vehicle below. If you are unsure if this will fit your vehicle, please contact an automotive dealer with the donor VIN to verify fitment.
LKQ Online is listing a used engine in good, working condition.
No photos of the actual engine are available. A Stock photo has been used as a general representation.
****ATTENTION: Stock photo shows multiple Engines. This listing is for 1 Engine ONLY****
Warranty covers the Long Block (Engine Block, Cylinder Heads, Head Gasket(s), Crankshaft, Pistons, Rods, Bearings, Oil Pump, Camshaft(s), Valves & Lifters).
There is NO core charge for this engine. To aid in installation, you get to keep your current engine and all attached accessories.
****Please Note: The number (LKQ~XXXXXXXX) in the title is for internal use only. This is NOT a manufacturer part number, and can be disregarded.****
This will fit:
Nissan Versa 2014-2015 (1.6L, VIN C, 4th digit, HR16DE)
Nissan Versa 2016-2016 (1.6L, VIN C, 4th digit, HR16DE), Hatchback (note)
Nissan Micra 2015-2017 (1.6L, VIN C, 4th digit, HR16DE)
Nissan Micra 2018-2019 (1.6L, VIN C, 4th digit, HR16DE), ID 10102-3VA1A
Important Information About Engine Warranty
(Warranty applies to parts that arrive defective/damaged or become defective within the warranty period)
What is Covered:
Engine warranties are limited to manufacturing defects in the Engine Block, Cylinder Head(s), Head Gasket(s), Crankshaft, Pistons, Rods, Bearings, Oil Pump, Camshaft(s), Valves & Lifters.
What is NOT Covered or Guaranteed to be included:
Installation Check List:
(Failure to complete the following will void Warranty)
– Determine why the original engine failure occurred and make appropriate repairs.
– Insure this engine is the same application as the one being replaced.
– Clear all computer diagnostic codes from the vehicle prior to installing.
– Exchange the oil pan and pick up tube.
– Inspect and replace gaskets & seals (front seal, rear main seal, valve cover gaskets, oil pan gaskets).
– On crankshaft bolts that are drilled through sealant must be applied to avoid leaks.
– Install new thermostat & gasket (warranty will be void if engine heat tab is melted or removed)
– Replace the timing belt.
– Remove all cap-plugs orifice covers.
– Replace water pump.
– Install replacement sparkplugs & wires.
– Exchange the flywheel and bolts.
– Exchange attached accessory items to insure proper fit (mounts, intake manifold, exhaust manifold, distributor, sensors).
– Disable fuel/ignition before attempting to start engine. This will allow the oil to prime as indicated by the manufacturer.
– Replace engine oil, oil filter, air filter, fuel filters, coolant-antifreeze.
– Drain excess oil and coolant from exhaust system.
– If equipped with an engine oil cooler the radiator or external cooler must be replaced.
– Insure the cooling system is flushed and functioning properly.
- Donor Vehicle & Part Information
- Vehicle Year: 2014
- Vehicle Make: Nissan
- Vehicle Model: Versa
- Vehicle VIN: 3N1CN7AP3EL848602
- Vehicle Engine Size: 1.6
- Vehicle Mileage: 88977
- Part # or Vehicle Model: Versa
- Warranty: 6 Month Warranty (Parts ONLY – NO Labor)
- Vehicle Stock #: $K69901-762
- Interchange: ENG77088A
- We are not affiliated with Nissan. All trademarks mentioned herein belong to their respective owners.
