Dear friends, thank you for choosing our electronic DIY suite! Please assemble it step by step as instructed below. During installation, if you have any question, or lose or damage any part, contact us directly! Our professional technicians will answer your question about installation. We provide lifelong technical support services for DIY products.
This is a DIY electronic kit for making a light tower.
After installed, the light tower is about 1.05 meter, it can display gorgeous dynamic effects. It is very suitable for training hands-on ability. It is also a very novel gift completely made by hand.
User need to solder 2112 LEDs, we provide standby LEDs.
User need to prepare soldering irons and solder wires by themselves.
The mainboard has had the relevant program downloaded and properly tested.
We provide a mold to assist soldering the LEDs to make soldering easier.
After the tower has been welded, plug in the power supply (5V) and it will display a built-in dynamic effect.
It uses 3mm LEDs.
The mainboard is 15x15cm in size.
It has built-in 20 kinds of flash effects.
The mainboard is powered by 5V USB.There are 6 buttons to switch animation modes.
- K1: Reset, go back to the first flash
- K2: Switch Flash effect / Audio effect
- K3: Current flash cycle / All flash cycle
- K4: Next Flash effect
- K5: Previous Flash effect
- K6: Pause / Run
- Soldered and tested mainboard x1
- Copper posts and screws x4
- USB cable x1
- White electronic line x 1
- Plastic mold for auxiliary welding x1
- 3mm Red LED x600(used 512)
- 3mm Green LED x600(used 512)
- 3mm Blue LED x600(used 512)
- 3mm White LED x600(used 512)
- 3mm Blue long LED x50(used 24)
